Abstract
The paper presents the results of computer simulation (on the example of grey cast iron of SCH 20 grade) of the influence of melt pouring direction on the degree of defects of shrinkage origin in the axial zone of the neck of a tensile sample when filling the mold cavity with a standard cast sample for optimal values of melt mass flow rate.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.