Abstract
In this work, rotating bending fatigue, scanning electron microscope in-situ fatigue, pre-fatigue (and post-fatigue) electron backscatter diffraction tests were carried out for rolled Ti–6Al–4V alloys. The macrozone sizes and orientations of the materials were classified and the effect of macrozones on fatigue cracking behavior and fracture mechanisms was studied. The results indicated that intra-granular fracture was dominated in the process of crack propagation. Basal and prismatic slip systems were favored for the macrozones whose crack paths were straight and zigzag, respectively. Multiple active slip systems can also induce the fatigue crack deflections inside grains. Moreover, fatigue crack propagation rate, threshold stress intensity factor range (ΔKth) and fracture toughness (KIC) were measured for different kinds of macrozones. For the macrozones favorably orientated for prismatic slip, their crack propagation resistance and ΔKth were excellent. However, the KIC values for different macrozones were similar. Finally, the effect of macrozone orientations on fracture mechanisms (cleavage and plastic fracture) was discussed through a combination of Schmid factor, active slip systems and the Δθ angle (between ɑ-Ti phase (0001) plane normals (c-axes) and cyclic load directions). The Δθ is an adequate parameter to predict the fatigue fracture modes.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
