Abstract
AbstractIn this study, the potential of recycled poly(ethylene terepthalate) (rPET) as a well‐defined reinforcing material for the in situ microfibrillar‐reinforced composite (iMFC) was investigated in comparison with that of liquid crystalline polymer (LCP). Each dispersed phase (LCP or rPET) was melt blended with high density polyethylene (PE) by using extrusion process. The rheological behavior, morphology, and the thermal stability of LCP/PE and rPET/PE blends containing various dispersed phase contents were investigated. All blends and LCP exhibited shear thinning behavior, whereas Newtonian fluid behavior was observed for rPET. The incorporation of LCP or rPET into PE significantly improved the processability. A potential of rPET as a processing lubricant by bringing down the melt viscosity of the blend system was as good as LCP. The elongated LCP domains were clearly observed in as‐extruded strand. Although the viscosity ratio of the rPET/PE system was lower than that of the LCP/PE blend system, most rPET domains appeared as small droplets. An addition of LCP and rPET into the PE matrix improved the thermal resistance significantly in air but not in nitrogen. The obtained results suggested the high potential of rPET as a processing aid and good thermally resistant material similar to LCP. Copyright © 2009 John Wiley & Sons, Ltd.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
