Abstract
In this work, we investigate, on a laboratory scale, the influence of the leaching conditions on the release of various chemical elements from a cementitious material obtained by solidification of PbO, Ni 2O3 and Cr2O3 with blended cement (CEMII-B32.5, according to European Standards). The pH effects on the pollutants release and the composition of the initial pore solution (target elements: chloride, sulfate, sodium, potassium, calcium, lead, chromium and nickel) were assessed through an experimental procedure consisting of two equilibrium leaching tests [the acid neutralization capacity (ANC) and the pore water (PW) tests] and the maximum mobile fraction (MMF) text. Samples of the same material were submitted in parallel to dynamic leaching tests in order to assess the influence of the boundary conditions (instantaneous liquid/solid (L/S) ratio, solution renewal) on the leaching kinetics of the target elements. The comparison criteria were the leachate saturation state, the released cumulative quantities and the leaching flux. Generally, leachate quantities obtained by the ANC, PW and MMF tests were important. However, the lowest released amount was observed for the monolith leaching test, and leachate saturation slowed down the dynamic release. Finally, experimental results highlighted another important parameter: the influence of the liquid/solid contact type on leaching kinetics.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
