Abstract
The effect of heat input on martensite formation and impact properties of gas metal arc welded modified ferritic stainless steel (409M) sheets (as received) with thickness of 4 mm was described in detail in this work. The welded joints were prepared under three heat input conditions, i.e. 0.4, 0.5 and 0.6 kJ/mm using two different austenitic filler wires (308L and 316L) and shielding gas composition of Ar + 5% CO 2 . The welded joints were evaluated by microstructure and charpy impact toughness. The dependence of weld metal microstructure on heat input and filler wires were determined by dilution calculation, Cr eq /Ni eq ratio, stacking fault energy (SFE), optical microscopy (OM) and transmission electron microscopy (TEM). It was observed that the microstructure as well as impact property of weld metal was significantly affected by the heat input and filler wire. Weld metals prepared by high heat input exhibited higher amount of martensite laths and toughness compared with those prepared by medium and low heat inputs, which was true for both the filler wires. Furthermore, 308L weld metals in general provided higher amount of martensite laths and toughness than 316L weld metals.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
