Influence of continuous use of a vacuum-forming machine for mouthguard thickness after thermoforming.

Abstract

Mouthguards can reduce the risk of sports-related injuries such as tooth fracture or avulsion, but the sheet material and thickness have a large effect on their efficacy and safety. The aim of this study was to investigate the effect of the continuous use of a vacuum-forming machine on mouthguard thickness. Ethylene vinyl acetate sheets and olefin copolymer sheets were used for thermoforming with a vacuum-forming machine. The working model was trimmed to a height of 23mm at the maxillary central incisor and 20mm at maxillary first molar. During molding, the model was placed at the center of the vacuum unit. Three molding conditions were investigated (i) molding was carried out after the sag at the center of the softened sheet was 15mm below the clamp (control); (ii) sheet heating started 5minutes after the control, and molding in the same way as the control (AF5); and (iii) sheet heating started 10minutes after the control, and molding in the same way as the control (AF10). Under each condition, vacuum forming was conducted for 30seconds. Sheet thickness after fabrication was determined for the incisal edge, labial surface, cusp, and buccal surface using a special caliper accurate to 0.1mm. The differences of the molding conditions on the thickness in each sheet material were analyzed by one-way analysis of variance and Bonferroni's multiple comparison tests. For both sheet materials, significant differences between the control and AF5 were observed at all measurement points (P<.01), but not between the control and AF10. Compared with the control, AF5 was thinner and AF10 was a similar thickness. The continuous use of a vacuum-forming machine led to a reduction in the thickness of the mouthguard. Intervals of 10minutes are necessary to achieve consistent molding.