Abstract
A dual phase steel with an initial coarse microstructure was refined, by means of a thermal treatment, to study the influence of the austenite grain size reached during an intercritical annealing treatment on the martensite start temperature. Thus, the effect of the austenite grain size on a subsequent overaging treatment was also investigated. It was found that a coarser austenite grain size leads to a higher martensite start temperature and a lower amount of non-tempered martensite and/or austenite (MA constituents) volume fraction after a continuous annealing and overaging treatment. The non-tempered martensite and/or austenite volume fraction always was higher for the highest overaging temperature.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
