Abstract
This paper deals with increasing the drawing height of metal conical square cups with anti-lock braking system (ABS). A novel technique enabling higher drawing height than that achieved in the conventional deep drawing process is introduced, and the principle of the process is explained in this paper. Results of experiments conducted using aluminum alloyed Al-1050 blanks of thickness of 1 mm to draw conical square cups are reported here. Measured drawing load, drawing height and thickness distributions were compared with those obtained from the conventional method. The experimental results showed that higher drawing height of the cup can be achieved by the use of ABS.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
