Abstract
The objective of the present work was to determine some force parameters for removal of an abutment from a dental implant in a frictional system (locking taper, 1.23 degrees). Ten implants of the same length (11mm) and different diameters were selected, along with 10 straight abutments (13mm length) with different diameters. Abutments were attached to implants without application of force. Fixation of the implant-abutment mount (IA) (repeated 1-5 times) was performed through the impact of a body weight (compression force, tapping) left from a known height. After each group of tappings, IA mounts were coupled with a tensile strength tester. The lowest removal value was found after the first tapping of mount #2 (83N, implant diameter 3.3mm/4.5mm abutment diameter), and the highest removal value happened with mount #8 after the fifth tapping (420N, 5.0mm/5.5mm). The force to remove IA mounts increased with the number of tappings and with the increase in abutment mass. Three activations (tappings) of the abutment were considered necessary to yield optimal stability, demonstrated by the large increase in removal force.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
