In Vitro Comparison of Direct Attachment Shape and Size on the Orthodontic Forces and Moments Generated by Thermoplastic Aligners During Expansion.

Abstract

To evaluate the effects of varying direct attachment shape and size on the forces and moments generated by thermoplastic aligners during simulated expansion. An invitro orthodontic force tester (OFT) was used to measure the forces and moments from a typodont where the buccal teeth were translated lingually 0.2 mm to simulate expansion. Hemi-ellipsoid and rectangular attachments with either 0.5 or 1.0 mm thickness were added on upper right first premolar (UR4), second premolar (UR5) and first molar (UR6). Analysis of variance (ANOVA) was used to determine two-way interactions among the factors on the outcomes. The interactions between group and tooth were significant for all outcomes (p < 0.001). The greatest buccal forces (Fy) were observed with 1 mm rectangular attachment on the UR4 (0.78 ± 0.29 N), with 1 mm hemi-ellipsoid attachment on UR5 (0.28 ± 0.21 N) and with 0.5 mm rectangular attachment on UR6 (1.71 ± 0.18 N). The greatest buccolingual moments (Mx) were obtained with 1 mm rectangular attachment on UR4 (5.61 ± 1.43 Nmm), without any attachments on UR5 (3.33 ± 1.73 Nmm) and with 1 mm hemi-ellipsoid attachment on UR6 (4.18 ± 4.31). Direct attachment shape and size had a significant effect on the orthodontic forces and moments generated by thermoplastic aligners during simulated expansion. Although loads varied significantly by tooth morphology and its location in the arch, best forces and moments for expansion were obtained with 1 mm rectangular attachments on UR4s, 1 mm hemi-ellipsoid attachments on UR5s and 0.5 mm rectangular attachments on UR6s.