Abstract
Alumina (Al2O3) and silicon nitride (Si3N4) ceramic compositions were studied as prospective materials for ballistic ceramics. Alumina ceramics with contents of 0, 5, 10 and 15 wt% of silicon nitride studied in order to improve their flexural strength/density ratio. Samples were molded by uniaxial pressing and sintered at 1600 °C. Retraction, density, water absorption and mass loss of the samples were determined, as well as their hardness, mechanical strength and fracture toughness. Ceramics produced in the presence of Si3N4 exhibited an interior with a very different aspect from their external surface. X-ray diffractometry showed that most compositions presented two phases, alumina and mullite, while the interior of the 15 wt% composition presented four phases: alumina, mullite, silicon nitride and X–SiAlON. Samples with 10 wt% of silicon nitride displayed the highest fracture toughness and the best flexural strength. Furthermore, this sample achieved a density approximately 21% lower than that of the control samples, providing the best flexural strength/density ratio, roughly 53% higher than that of alumina without Si3N4. Thus, these ceramics show great potential for utilization in advanced ceramic protections, where weight is a major limiting factor.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
