Abstract
To improve the fretting fatigue strength of splined shaft used for compressor of car air conditioner, press-fit joint was combined with the spline joint. Torsional fretting fatigue strength of the combined jointed shaft was evaluated focusing on the effect of press-fit interference which must be secured when the combined joint is applied to the production process. Torsional fretting fatigue strength of the splined shaft was drastically increased by the combination of press-fit. The improvement was achieved by sharing transmitted torque between press-fit and spline. While fretting fatigue failure occurred at the press-fitted part when the press-fit interference was relatively small, the combined jointed shaft had four times higher fatigue strength than the conventional splined shaft. The increase of press-fit interference prevented the fretting fatigue failure and brought further increase of the fatigue strength, since amount of relative slip was significantly reduced by the increase of contact pressure.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
