Abstract

Implementation and vehicle tests of a vehicle longitudinal control algorithm for stop-and-go cruise control have been performed. The vehicle longitudinal control scheme consists of a set-speed control algorithm, a speed control algorithm, and a distance control algorithm. A desired acceleration for the vehicle for the control of vehicle-to-vehicle relative speed and clearance has been designed using linear quadratic optimal control theory. Performance of the control algorithm has been investigated via vehicle tests. Vehicle tests have been conducted using two test vehicles. A 2000 cm3 passenger car equipped with a radar distance sensor, throttle/brake actuators and a controller has been used as a subject vehicle in the vehicle tests. A millimetre wave radar sensor has been used for distance measurement. A step motor and an electronic vacuum booster have been used for throttle/brake actuators. It has been shown that the implemented vehicle longitudinal control system can provide satisfactory performance in vehicle set-speed control and vehicle clearance control at lower speeds.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.