Impingement heat transfer by jet issuing from a cross-shaped nozzle

Abstract

Heat transfer characteristics and flow patterns were measured over a plate for various separation distances between the nozzle exit and target plate when air issues from a sharp-edged cross-shaped nozzle and impinges on a plate. The local heat transfer coefficients in the radial direction for different circumferential positions were calculated using the wall temperatures measured by means of thermocouples, and flow patterns were observed using an oil-titanium IV oxide method. The isotherms of the infrared images were also measured using an infrared radiometer with a two-dimensional array of indium-antimony (InSb) sensors. The geometric axes were switched as a result of the self-induced velocity of a vortex filament; the convex corners became flat and the concave corners generated outward ejection. The distributions of the iso-heat transfer coefficient contours correspond well to the flow pattern and the isotherm contours. These contours extended diagonally and demonstrated the St. Andrew's cross pattern for short separations, subsequently changing to an octagonal pattern, and then becoming circular at large separations. The correspondence of the heat transfer characteristics to the flow behavior, as well as the heat transfer mechanism are also described. © 1998 Scripta Technica, Heat Trans Jpn Res, 27(3): 192–204, 1998