Impacts of CF+, CF2+, CF3+, and Ar Ion Beam Bombardment with Energies of 100 and 400 eV on Surface Modification of Photoresist

Abstract

Photoresists used in advanced ArF-excimer laser lithography are not tolerant enough for plasma etching processes. Degradation of photoresists during etching processes might cause not only low selectivity, but also line edge roughness (LER) on the sidewalls of etched patterns. For a highly accurate processing, it is necessary to understand the mechanisms of etching photoresists and to construct a new plasma chemistry that realizes a nano scale precise pattern definition. In this study, the modified layers formed on the surface of a photoresist by the bombardment of fluorocarbon ions of CF+, CF2+, and CF3+, and argon (Ar) ions were analyzed by X-ray photoelectron spectroscopy (XPS). The etching yield of the modified steady-state surface was almost dependent on the mass of incident ion species. The surface composition was modified with increasing dosage of each ion species, and reached a specific steady state that was dependent on the ion species. The bombardment of F-rich ion species such as CF2+ and CF3+ resulted in the formation of not only fluorocarbon layers, but also graphite like structures on the surface. On the basis of these results, the surface reaction for the ion-beam-induced modification was discussed.