Abstract
In this research work, the low‐velocity impact behavior and post impact performance of carbon/epoxy laminates modified with milled glass fibers was investigated. Unidirectional (UD) and Cross‐ply (CP) carbon/epoxy laminates were incorporated with milled glass fibers by 5 wt% of epoxy. Low‐velocity impact test was performed at impact velocity of 3, 3.5, 4, 4.5, and 5 m/s, respectively and the results were correlated with the baseline samples without filler. The filler loaded samples exhibited higher peak force, lesser deformation, and lower damage degree than the baseline samples. The milled glass fibers in the interlaminar zone restricts the delamination crack propagation resulting in reduced impact damage area and also promotes additional energy dissipation mechanism including filler debonding/pullout. Furthermore, the CP filler‐loaded samples show higher residual load‐bearing capacity for impact velocities 3, 3.5, and 4 m/s, respectively. Although the unidirectional filler‐loaded samples showed better load bearing capacity for impact velocities beyond 4 m/s. POLYM. COMPOS., 40:2441–2451, 2019. © 2018 Society of Plastics Engineers
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.