Impact of trace silicon on irradiation hardening and embrittlement of RAFM steel subjected to neutron irradiation

Abstract

The content of silicon (Si) element in reduced activation ferritic/martensitic (RAFM) steels varies significantly among different candidates of fusion reactor structural materials. Si is not intentionally added to the RAFM steel but rather remains as a residue during the deoxidation process in steel fabrication. To control and reduce the Si content, removing processes and special treatments are required. The additional refining processes significantly increase the cost of steel fabrication. Currently, the role of residual or trace Si in neutron irradiation of steel remains unclear. In the presented study, two 9Cr-2 W RAFM steels with Si contents of 0.1 wt.% and 0.01 wt.% were fabricated and subjected to a neutron irradiation at 563 K with a neutron fluence of 4.8 × 1023m−2. The main results show that 0.1 wt.% Si can contribute to the suppression of irradiation hardening and embrittlement, as evidenced by the reduction in irradiation-increased hardness and yield strength, while maintaining preferable elongation. Microscopic analysis suggests that an appropriate content of Si helps refine the grains in RAFM steel, increases the ductile fracture region of the fracture surface, and effectively reduces the density of dislocation loops induced by neutron irradiation. The findings evidence that retaining a certain amount of trace Si should be an informed and rational choice in the design of RAFM steel.