Impact of additional sidebands generated by a tapered amplifier on an atom interferometer.

Abstract

Stimulated Raman transitions are often used in an atom interferometer (AI) for wave packet manipulation. Normally, two lasers with different frequencies contained in a Raman beam are combined first and then amplified by a single tapered amplifier (TA). This configuration can simplify the laser system of the AI, however, additional sidebands will be generated by the TA because of the nonlinear effect in the TA. In this work, the impact of additional sidebands generated with a single TA on the AI is studied. We first observe the additional sidebands in a Raman laser by a Fabry-Pérot interferometer (FPI), and the additional sidebands will be greatly suppressed by reducing the injection laser power of the TA. This is also confirmed by observing the position-dependent Raman transitions induced by additional sidebands at different injection power in an AI. However, the phase shifts induced by additional sidebands are not reduced obviously when the injection power of the TA is reduced. Therefore, it is necessary to separately amplify two lasers contained in the Raman laser by two TAs for a high precision AI. The spectroscopy of Raman laser generated by two TAs is also measured by the FPI, and the impact of additional sidebands on the AI is eliminated. This work has guiding significance for the design of the laser system in a high-precision AI.