Abstract
BackgroundThe watershed line is widely accepted as the distal limit of the volar locking plate (VLP); however, the VLP placement could vary depending on the plate contour and morphology of the distal radius. The aim of this study was to investigate the morphology of the distal radius and VLP fitting using 3D images. HypothesisWe hypothesized that attachment of the VLP would affect the contour of the volar prominence of the distal radius. Patients and methodsVariable-angle LCP two-column volar distal radius plate 2.4 and 16 formalin-fixed cadavers were studied. The plate and forearm were scanned using a computed tomography scanner. The plate was fixed to the radial shaft in the most distal position without flexor pollicis longus tendon contact. Postero-antero and lateral radiographs were obtained using fluoroscopy. Postero-antero radiographs were superimposed on a 3D image of the distal radius. The virtual plate was attached to the distal radius in the computer simulations, and the plate was adjusted in the sagittal plane. In the postero-antero radiographs, the distance between the plate and distal end of the radius (DPR) was measured. In the sagittal plane, the height of the volar lunate facet (VLF) and the plate-to-bone distance of each locking screw hole was measured. The volar cortical angle (VCA) was measured as the angle formed by a line drawn along the volar surface and a line drawn on the radial shaft on the sagittal plane at each locking screw plane. ResultsA significant correlation was observed between the height of the VLF and the DPR, and between the height of the VLF and the VCA. The plate-to-bone distance at the ulnar screw hole was significantly smaller than that of the other screw holes. DiscussionOur study revealed that the higher the VLF, the more proximal is the VLP. The plate fits on the bone surface at the ulnar side, whereas the radial side has more space between the plate and bone. Level of evidenceIII, diagnostic Level.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Revue de Chirurgie Orthopedique et Traumatologique
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.