Identification of the Facial Colliculus in Two-dimensional and Three-dimensional Images.

Abstract

The facial colliculus (FC), an important landmark for planning a surgical approach to brainstem cavernous malformation (BCM), is a microstructure; therefore, it may be difficult to identify on magnetic resonance imaging (MRI). Three-dimensional (3D) images may improve the FC-identification certainty; hence, this study attempted to validate the FC-identification certainty between two-dimensional (2D) and 3D images of patients with a normal brainstem and those with BCM.In this retrospective study, we included 10 patients with a normal brainstem and 10 patients who underwent surgery for BCM. The region of the FC in 2D and 3D images was independently identified by three neurosurgeons, three times in each case, using the method for continuously distributed test results (0–100). The intra- and inter-rater reliability of the identification certainty were confirmed using the intraclass correlation coefficient (ICC). The FC-identification certainty for 2D and 3D images was compared using the Wilcoxon signed-rank test.The ICC (1,3) and ICC (3,3) in both groups ranged from 0.88 to 0.99; therefore, the intra- and inter-rater reliability were good. In both groups, the FC- identification certainty was significantly higher for 3D images than for 2D images (normal brainstem group; 82.4 vs. 61.5, P = .0020, BCM group; 40.2 vs. 24.6, P = .0059 for the unaffected side, 29.3 vs. 17.3, P = .0020 for the affected side).In the normal brainstem and BCM groups, 3D images had better FC-identification certainty. 3D images are effective for the identification of the FC.