Abstract
The objective of this paper is to investigate the flow regimes of three phase flow, emerged to be as two phase flow. These two phases are air phase and oil dispersed in water phase, in other words the latter phase can be termed as water–oil emulsion phase or simply emulsion phase. Pipeline emulsions flow is inescapable for upstream oil production system in transporting mixtures of crude oil and water. The mixing, turbulence as well as agitation through wellbores, expansion or contraction, valves, pumps, etc. will emulsify either the oil phase or water phase, depending on the volumetric amount of the phases. This is executed in a flow loop system with varying air and liquid-emulsion velocities. The oil percentages to create the water–oil emulsion are varied from 0% to 24%. Flow pattern maps are developed at low range of fluid velocities (0.01–0.1 ms−1) and it is compared with established maps. Stratified smooth (SS), stratified to stratified-wavy (SSW), stratified wavy (SW) and stratified wavy with ripples (SWR) are the flow patterns, observed in the experiment. The stratified smooth and stratified to stratified-wavy flow regimes are found to be the most dominant. Oil dispersed in the water (emulsion) phase results a clear distinction of the stratified and the stratified-wavy regimes. An increase in flow regime area occupied by stratified/stratified-wavy in the flow pattern map is evident with increasing oil percent in the dispersed liquid phase. The addition of oil to the liquid phase causes a dampening effect on the flow regime transition, most considerably from stratified to nearly non-stratified flow. This might be attributed to the increase in viscosity at high oil percentages. The pressure drop is not significant in the whole flow phenomena and is found to increase with increasing liquid velocity for all oil percentages as the velocity range of the experiment is very low (0.01–0.1 ms−1). Pressure drop and liquid hold up are compared with previous theories and our prediction. Experimental data are predicted with approximately ±10% deviation.
Highlights
Multiphase flow is the general term used to describe the simultaneous flow of two or more phases
There was an experiment performed by Aswad, Hamad-Allah, and Alzubaidi (2006) with water, kerosene and air flowing through a 0.051 m inner diameter, 4 m long horizontal pipe where the effect of liquid flow rates and water ratios were observed for stratified flow
They found that the results showed good similarity with that obtained from the three phase model of Taitel et al (1995) for liquid and water thicknesses, as well as system pressure drop in the pipe
Summary
Multiphase flow is the general term used to describe the simultaneous flow of two or more phases. The oil had a density of 820 kg/m3 and viscosity of 2cP at 30°C They compared their results with that of the mechanistic model which yielded a good prediction of the water and oil film thickness in the pipe. They said that an increase in the liquid phase velocity led to a more significant increase in water layer thickness compared to the increase in the oil layer thickness. It was observed that the pressure drop increased with increasing liquid phase velocity They found that the results showed good similarity with that obtained from the three phase model of Taitel et al (1995) for liquid and water thicknesses, as well as system pressure drop in the pipe
Sign-in/Register to view highlights & summary Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
