Abstract

A chemical method utilizing sol-gel reactions was investigated to uniformly incorporate small amounts of additives of Si and Ca into nanocrystalline Mn 0.6Zn 0.4Fe 2O 4 powders (≈14 nm particle size). Sintering behavior of the chemically modified nanocrystalline MnZn ferrites was studied with regard to the effects of the chemical additives and sintering conditions on densification and grain growth. The nanopowder samples without the additives exhibited abnormal grain growth regardless of heating rate after pressing at a relatively low pressure and sintering at 1200°C, while the chemical addition of 2 wt% SiO 2 and 0.5 wt% CaO was found to improve microstructural characteristics, i.e., homogeneous grain growth and less porosity. Fast-firing did not seem to favorably affect densification of the chemically modified MnZn ferrite nanopowder, but was found to contribute to the suppression of grain growth in the nanocrystalline ferrite compacts.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.