Abstract
The porous media approach is regarded as an appropriate methodology for hydraulic simulations of complex pebble beds in fusion reactors. In order to determine the parameters (permeability α and inertial loss coefficient C) of the porous media accurately, two methods are proposed: the correction method and the fitting method. In this paper, a single-channel model with sequentially packed pebbles is constructed in order to obtain the pressure drop gradient against superficial velocities. Two methods, the correction method and fitting method, are employed to determine the permeability and inertial loss coefficient, and the results are evaluated with comparisons. Based on the results, both the correction method and fitting method are deemed feasible for the parameter determinations. In consideration of the consumption of resources and time for simulation, the fitting method is recommended during the preliminary design phase to shorten the duration of design, while the correction method is suggested to obtain precise results when the design is accomplished. Both of the methods would be evaluated with the data obtained from experiments in the future.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.