HKUST-1-Catalyzed Chan–Evans–Lam C–O Coupling Under Mild Conditions with Catalyst Reusability

2-Arylbenzothiazoles were synthesized via condensation of 2-aminothiophenol and different aldehydes catalyzed by nano silica-supported boron trifluoride (nano BF3/SiO2) as an efficient and reusable catalyst in high yields and short reaction times. The reactions proceeded at room temperature under mild conditions to afford 2-arylbenzothiazole derivatives. The pure products were identified and characterized by physical and spectroscopic data such as IR, 1H NMR, 13C NMR and Mass spectroscopy.

The selective oxidation of alcohols is one of the most challenging reactions in green chemistry. Although a number of methods have been developed, the search for new, facile, cost-effective, and environmentally benign procedures that avoid the use of a large excess of toxic and expensive stoichiometric metal oxidants has attracted substantial interest. An attractive method is the direct oxidation of alcohols—promoted by reusable heterogeneous catalysts—using air or molecular oxygen (O2) under solventfree conditions or (in the case of solid alcohols) in green organic solvents. Ideally, the reaction should also be performed under mild conditions (preferably at room temperature) for the synthesis of complex, thermolabile compounds, which are typical in fine chemistry. Satisfactory results were attained in only very few cases, in which a large excess of base additives was required, and this was usually achieved at the expense of selectivity. Therefore, the development of excellent reusable catalysts for liquid-phase aerobic oxidation of alcohols under mild conditions would constitute a breakthrough in both green chemistry and organic synthesis. Recently, supported gold nanoparticles have attracted considerable attention because of their extraordinarily high activity and selectivity. The outstanding catalytic ability of gold is related to the size and shape of the nanoparticles, the degree of coordinative unsaturation of the gold atoms, and the interactions between gold and the oxide support. Although several gold systems have been reported for the catalysis of alcohol oxidation reactions, in most cases they have been applied at temperatures above 100 8C. Dehydrogenation is known to be the rate-limiting step in the oxidation of alcohols on various noble metals. Therefore, the combination of gold nanoparticles with a suitable support (characterized by an exceptional alcohol-dehydrogenation activity) may allow the fabrication of new, versatile gold catalysts that could be used for liquid-phase organic synthesis under mild conditions. Herein, we demonstrate for the first time that mesostructured Ga–Al mixed-oxide solid solutions are highly promising supports for the fabrication of exceptionally effective gold catalysts for aerobic alcohol oxidation under mild conditions. A series of binary mesostructured Ga–Al mixed-oxide supports (denoted as GaxAl6 xO9; x= 2, 3, 4), along with unitary oxides of g-Ga2O3 and g-Al2O3, was prepared through an alcoholic sol–gel pathway. The X-ray diffraction (XRD) patterns of all as-synthesized binary substrates are characteristic of g-Ga2O3/Al2O3 solid solutions with a spinel-type structure. When gold nanoparticles were deposited onto these high-surface-area materials, no gold diffraction line was detected, and the pattern showed no significant differences relative to that of the support, thus indicating that the structure of the catalyst was maintained. A representative transmission electron microscopy (TEM) image of the Au/ GaxAl6 xO9 sample confirms that the gold particles were evenly deposited on the Ga–Al mixed-oxide support, with most particles being smaller than about 6 nm (see the Supporting Information for TEM and XRD data). To check the possible alcohol-dehydrogenation capability of the Au/GaxAl6 xO9 materials, we adsorbed 2-propanol on their surface and performed temperature-programmed surface reaction (TPSR) measurements of the desorbed H2 molecules (see the Supporting Information). Ga-containing mixed-oxide supports were found to be indispensable for attaining highly active alcohol-dehydrogenation materials (Figure 1A). Furthermore, the dehydrogenation activity of the catalysts was observed to be strongly dependent on the composition of these supports. A strongly enhanced hydrogen signal was identified in the case of a Ga3Al3O9 solid solution containing a Ga/Al molar ratio of 1:1—in sharp contrast to what was observed for the reference gold catalysts Au/TiO2 and Au/Fe2O3 (provided by the World Gold Council), where no H2 species were detected. These results can be rationalized by assuming that the formation of Ga–Al mixed-oxide solid solutions may favor the creation of specific dehydrogenation sites as a consequence of the presence of Ga atoms at the surface atomic sites (Td and Oh) of Al2O3 and highly dispersed GaO4 tetrahedra in the surface spinels. [16] These sites are responsible for the considerably enhanced dehydrogenation activity observed for the Ga–Al mixed-oxide-supported Au catalysts. Our initial aerobic-oxidation studies focused on the case of benzyl alcohol (Figure 1B), with the aim to understand the effect of the composition of the support on the catalytic performance of the gold catalysts. The reactions were performed in a magnetically stirred glass batch reactor in the presence of a solvent (at 90 8C) under O2 and at [*] F. Z. Su, Dr. Y. M. Liu, L. C. Wang, Prof. Y. Cao, Prof. H. Y. He, Prof. K. N. Fan Department of Chemistry and Shanghai Key Laboratory of Molecular Catalysis and Innovative Materials Fudan University, Shanghai 200433 (P. R. China) Fax: (+86)21-6564-2978 E-mail: yongcao@fudan.edu.cn

Facet and dual vacancy engineering-boosting BiOBr for enhanced CO2 and epoxide cycloaddition reaction under mild and cocatalyst-free conditions: Double substrate active sites and activated surface bromine ions synergy

Ultrafine PdRu Nanoparticles Immobilized in Metal–Organic Frameworks for Efficient Fluorophenol Hydrodefluorination under Mild Aqueous Conditions

Addressed herein is a facile one-pot synthesis of graphene hydrogel (GHJ) supported Pd nanoparticles (NPs), namely Pd-GHJ nanocomposites, via a novel method that comprises the combination of hydrothermal treatment and polyol reduction protocols in water. The structure Pd-GHJ nanocomposites were characterized by TEM, HR-TEM, XRD, XPS, Raman spectroscopy and BET surface area analysis. Then, Pd-GHJ nanocomposites were used as a heterogeneous catalysts in the tandem dehydrogenation of ammonia borane and hydrogenation of nitroarenes (Ar–NO2) to anilines (Ar–NH2) in the water/methanol mixture at room temperature. A variety of Ar–NO2 derivatives (total 9 examples) were successfully converted to the corresponding Ar–NH2 by the help of Pd-GHJ nanocomposites catalyzed tandem reactions with the conversion yields reaching up to 99% in only 20 min reaction time. Moreover, Pd-GHJ nanocomposites were demonstrated to be the reusable catalysts in the tandem reactions by preserving their initial catalytic performance after five consecutive catalytic cycles. It is believed that the presented synthesis protocol for the Pd-GHJ nanocomposites and the catalytic tandem hydrogenation reactions will make a significant contribution to the catalysis and synthetic organic chemistry fields.

Heterogeneous catalysis of alkenes to alkanes is of great importance in chemical industry, but more efficient and reusable heterogeneous catalysts are still demanded. Here, we report a metallically gradated composite of a silicon nanowire array and palladium nanoparticles which are reused for the hydrogenation of an alkene. The catalyst promotes the hydrogenation of stilbene with atmospheric hydrogen (0.1 MPa) to give diphenylethane quantitatively. The recovered catalyst can be reused, and mediates the reaction without loss of yield more than one hundred times, whereas the stability of Pd/C degrades rapidly over 10 cycles of reuse. The catalyst allows the hydrogenation of a variety of alkenes, including tetra-substituted olefins. Structural investigation reveals that palladium nanoparticles are metallically gradated onto the silicon nanowire array under mild conditions by agglomeration of palladium silicide, as confirmed by XAFS and XPS together with argon-ion sputtering. This means of metal agglomeration immobilization may be applicable to the preparation of a variety of metal nanoparticle catalysts.

In this study, the metal complex (5,10,15,20‐tetrakis‐(4‐sulfonatophenyl)‐porphyrin manganese (III) chloride; denoted as MnTSPP) represents a promising efficient and reusable heterogeneous solid catalyst for facile and highly efficient one‐pot synthesis of 1,4 dihydropyridine derivatives via three‐component condensation reaction of aromatic aldehyde, ethyl acetoacetate, and ammonium acetate under green and mild reaction conditions. The simple operation, short reaction time (15 min), and the high efficiency (99%) are the special advantage of this protocol. Furthermore, the green aspects of this synthetic protocol were more studied by examination of the reusability of MnTSPP for four consecutive cycles without a significant loss of catalytic activity. Remarkably, the new synthesis presented advantages in terms of safety, commercially available catalyst, simplicity, stability, mild conditions, short reaction time, and excellent yields, using a mixture of H2O and C2H5OH environmental‐friendly solvent, operationally facile, wide tolerance of starting materials, and excellent recoverable of the catalyst.

A highly efficient and general method is applied for the multicomponent synthesis of quinazolinone derivatives from cyclocondensation of aromatic aldehydes and dimedone with 2-amino benzimidazole or 3-amino-1,2,4-triazole using nano-SiO2 as a catalyst in acetonitrile at room temperature. In this method, nano-SiO2 was used as a green and reusable catalyst. This synthetic method provides several advantages including excellent yields, short reaction times, simple workup, mild conditions and inexpensiveness, green, and recyclable.

A highly efficient and simple protocol for the preparation of 2-aminobenzothiazoles through the reaction of potassium thiocyanate and substituted anilines in the presence of nano-BF3/SiO2 as a reusable heterogeneous catalyst is described. In this method, all of the 2-amino-substituted benzothiazoles were obtained in high to excellent yields and short reaction times under mild conditions. The structures of the resulting products were characterized and confirmed by melting point, FT-IR, 1H NMR and 13C NMR techniques. A highly efficient and simple protocol for the preparation of 2-aminobenzothiazoles by reaction of potassium thiocyanate and substituted anilines in the presence of nano-BF3/SiO2 as a reusable heterogeneous catalyst is described.

Pd-MnOx nanoparticles dispersed on amine-grafted silica: Highly efficient nanocatalyst for hydrogen production from additive-free dehydrogenation of formic acid under mild conditions

Paal–Knorr reaction catalyzed by metal–organic framework IRMOF-3 as an efficient and reusable heterogeneous catalyst

Stabilization of Au-nanoparticle-decorated postsynthesis-modified Cu(BDC-NH2) MOF as a reusable heterogeneous catalyst in an intermolecular hydroamination of allenamides with arylamines

A robust heterogeneous self-supported chiral titanium cluster (SCTC) catalyst and its application in the enantioselective imine-cyanation/Strecker reaction is described under batch and continuous processes. One of the major hurdles in the asymmetric Strecker reaction is the lack of availability of efficient and reusable heterogeneous catalysts that work at room temperature. We exploited the readily hydrolyzable nature of titanium alkoxide to synthesize a self-supported chiral titanium cluster (SCTC) catalyst by the controlled hydrolysis of a preformed chiral titanium-alkoxide complex. The isolated SCTC catalysts were remarkably stable and showed up to 98 % enantioselectivity (ee) with complete conversion of the imine within 2 h for a wide variety of imines at room temperature. The heterogeneous catalysts were recyclable more than 10 times without any loss in activity or selectivity. The robustness, high performance, and recyclability of the catalyst enabled it to be used in a packed-bed reactor to carry out the cyanation under continuous flow. Up to 97 % ee and quantitative conversion with a throughput of 45 mg h(-1) were achieved under optimized flow conditions at room temperature in the case of benzhydryl imine. Furthermore, a three-component Strecker reaction was performed under continuous flow by using the corresponding aldehydes and amines instead of the preformed imines. A good product distribution was obtained for the formation of amino nitriles with ee values of up to 98 %. Synthetically useful ee values were also obtained for challenging α-branched aliphatic aldehyde by using the three-component continuous Strecker reaction.

New Pt(0) nanoparticles were easily and reproducibly prepared by the simultaneous reduction method using 1-butylamine (BA) and tributylamine (TBA) for the first time as capturing ligands at room temperature. X-ray diffraction, X-ray photoelectron microscopy and transmission electron microscopy measurements verify the formation of well-dispersed Pt(0) nanoparticles [~3.63 and ~3.98 nm for catalysts prepared using BA (catalyst I) and TBA (catalyst II), respectively] on an activated carbon surface. The catalytic performances of these nanoparticles in terms of activity, isolability and reusability were investigated for both alcohol oxidation and the dehydrocoupling of dimethylamine-borane (DMAB). These nanoparticles were shown to be as active and reusable heterogeneous catalysts even at room temperature. The prepared catalysts can catalyze the dehydrogenation of DMAB with one of the highest known activities at room temperature and also C1–C3 alcohol oxidation with very high electrochemical activities.

Although platinum nanoparticles and complexes ‐especially of Pt(0) and Pt(II)‐ are well known catalysts, siloxane‐based platinum complexes are rarely reported. Herein, a Platinum(IV) complex of 4‐aminopyridinium‐modified disiloxane was prepared and characterized by medium and far infrared spectroscopy, NMR and EDX. The formation of the complex was monitored by UV–Vis spectroscopy, which showed the high affinity and selectivity of this ligand for Pt, with a stability constant of 7.53·103 M−1. The catalytic activity of the siloxane‐based complex was tested in three types of reactions: reduction of p‐nitrophenol, oxidation of glucose and starch, and hydrosilylation. The hydrophobic behavior of the permethylated disiloxane moiety ensures good hydrolytic stability, while the N‐donor ligand stabilizes thein‐situformed Pt nanoparticles. The generation of Pt nanoparticles during p‐nitrophenol reduction was confirmed by TEM and SEM. Contrary to most reports, the aerobic oxidation of mono‐ and polysaccharides occurred without oxidation agents or mediators added, in mild conditions, at room temperature and pH ~9. The same metal complex was found active in hydrosilylation of vinyl‐siloxanes with temperature‐modulated rate, thus being useful in silicone cross‐linking systems without the need of inhibitors. The method was adapted to one‐pot synthesis of silica‐supported Pt(IV) complex, which acted as efficient and reusable heterogeneous hydrosilylation catalyst, limiting the contamination of the product with Pt. This approach is promising for superior valorization of scarcely available and expensive platinum metal. By the same method, multifunctional soluble complexes and mesoporous silica may be obtained, with tunable catalytic performance.