Abstract
ABSTRACT: For the rod shape measurement of hot rolled round steel bars (rods) the high frequency eddy current method is especially well suited as it requires no contact point and is not limited to bellow the Curie Temperature. Defects of the rod’s shape can be detected by measuring the impedance spectrum of the RLC-oscillator. In the first laboratory setup ( Weidenmuller, Knopf, Sehestedt, and Himmel 2008) an Agilent Impedance Analyser was used for initial tests. Nevertheless, this setup cannot be applied in a steel plant due to the difficult environmental conditions and low data acquisition rate. Hence, a Vector Network Analyser for passive impedance measurement that is applicable in these surroundings was developed, (Weidenmuller, Sehestedt, Kanoun, and Himmel 2009).
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.