Abstract
A miniaturepolymer Bragg grating (PBG) sensor is fabricated and employed for ultrasonic imaging of seismic physical models (SPMs). The sensing Bragg grating is inscribed into an ultraviolet (UV) glue polymer waveguide with a femtosecond laser. The uniform polymer waveguide is fabricated by sealing the UV glue into a capillary fibre through capillary effect. By using line-by-line inscription technique, the laser beam is scanned transversely to periodically modulate the refractive index of the polymer waveguide, leading to the formation of the PBGs with various grating lengths. The sensor response to ultrasonic waves are investigated experimentally. When compared to single-mode fiber Bragg grating and phase-shifted fiber Bragg grating, the PBG with the same reflectivity presents a higher response amplitude due to its lower Young’s modulus. Besides, the sensor has a good spectral stability when transferred from air to water due to the waterproof coating on the sensor end. Finally, the sensor is used to scan a large-scale 3D SPM and the structural features, such as fault, fluctuation, and depositional termination, can be distinctly reconstructed. The proposed PBG sensor provides a new technique with easy fabrication, high sensitivity, and good stability for high-fidelity ultrasonic imaging of seismicphysical models.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
