High temperature mechanical properties and microstructure of hard TaSiN coatings

Abstract

Room and high temperature mechanical properties of reactive magnetron sputtered TaSiN coatings were measured using nanoindentation (between 25 °C and 500 °C). Fracture toughness was also evaluated at a similar temperature range using the micropillar splitting method. The influence of the nitrogen concentration on the evolving phases and microstructure of the TaSiN coatings, before and after the high temperature testing, were examined by X-ray diffraction (XRD) and transmission electron microscopy (TEM) analysis. XRD spectra showed broad peaks with hexagonal γ-Ta2N as the main phase, with the cubic δ-TaN phase emerging for higher N contents. Phase composition remained unchanged before and after the 500 °C tests. However, after the high temperature tests, TEM analysis showed the presence of an oxide surface layer, with a thickness that decreased (from 42 to 15 nm) with N content, due to residual oxygen diffusion, which replaces nitrogen to form amorphous SiOx. Beneath the oxide-rich surface layer, coatings exhibited a stable nanocrystalline columnar microstructure. Hardness and fracture toughness increased with N content, initially due to the formation of an amorphous Si–N tissue at grain boundaries, and for even higher N contents, due to the appearance of the hard cubic δ-TaN phase. Hardness at 500 °C decreased only by 15%, while fracture toughness followed the opposite trend, due to increased plasticity with temperature. The optimum composition turned out to be Ta55Si10N35, which retained a hardness of 30 GPa at 500 °C, being also the toughest. These observations make this system very interesting for high temperature applications.