High-pressure crystallization of isotactic polypropylene droplets

Abstract

Dispersions of isotactic polypropylene (PP) particles in polystyrene (PS) were produced by interfacially driven breakup of nanolayers in multilayered systems that were fabricated by means of layer-multiplying coextrusion. The droplet size was controlled by the individual PP layer thickness ranging from 12 to 200 nm. In addition, PP was melt blended with PS to produce PP droplets larger than those formed by breakup of nanolayers. The dispersions of PP particles in the PS matrix were melted and annealed under high pressure of 200 MPa. Only the largest PP droplets, with average sizes of 170 μm, crystallized predominantly in the γ form. In the 42-μm droplets obtained by breakup of 200 nm layers, a minor content of the γ form was found whereas the smaller droplets obtained by breakup of the thinner nanolayers contained the α form and/or the mesophase. The results showed that the γ phase formed only in the droplets sufficiently large to contain the most active heterogeneities nucleating PP crystallization under atmospheric pressure. It is concluded that the presence of nucleating heterogeneities is necessary for crystallization of PP in the γ form under high pressure.