High‐performance polymer films. III. Preparation and characterization

Abstract

AbstractA series of polyimide and copolyimide films were prepared by film casting, drying, and thermal imidization from the respective precursor poly(amic acid) (PAA) and copoly(amic acid) solutions derived from two dianhydrides, pyromellitic dianhydride (PMDA) and 3,3′,4,4′‐benzophenonetetracarboxylic dianhydride (BTDA), and two diamines, 4,4′‐oxydianiline (ODA) and a proprietary aromatic diamine (PD) as monomers. Depending on the solution's inherent viscosity value (molecular weight) and the nature of the polymer chains (derived from rigid or flexible monomers), precursor poly(amic acid) and copoly(amic acid) solution concentrations of 8–12% (w/w) were found to be suitable for the preparation of good quality polyimide/copolyimide films. The recovery of film toughness and creasability from the brittleness at the intermediate temperature of the cure cycle depended not only on the molecular weight of the precursor poly(amic acids)/copoly(amic acids) but also on their chain flexibility. The poly(amic acid) derived from both rigid dianhydride and diamine practically gave rise to a brittle film of polyimide even after curing to 360°C. The resulting polyimide and copolyimide films were compared with Du Pont's Kapton H film. The density of the films was in the range 1.39–1.42 g/cm3. The thickness of most of the films was in the range 20–30 μm. The HPF 3 film, based on PMDA–PD, appeared to be highly colored (reddish brown), and the HPF 2 film, based on BTDA–ODA, had the lightest yellow coloring among the films in this investigation, including Kapton H film. HPF 2, HPF 6, and HPF 8 films were more amorphous than the other films. © 2001 John Wiley & Sons, Inc. J Appl Polym Sci 82: 976–988, 2001