Heat Transfer to Steam-Water Annular Dispersed Flow in Vertical Annulus

Abstract

The heat transfer coefficient and slow burnout heat flux were measured for a stream-water annular dispersed upward flow under pressures up to 3.5 ata in an electrically heated vertical annular channel. An empirical equation was derived for the heat transfer coefficient as function of mass flow rate, steam quality and heat flux. The dominant mechanism of heat transfer to the annular dispersed two-phase flow is forced convection of liquid film on the heater surface even in the region of low steam quality (down to about 0.03). The observed slow burnout heat flux was near the point of intersection of the lines representing liquid film forced convective heat transfer and nucleate boiling heat transfer on the q vs. δT sat diagram. A dryout mechanism is proposed in which increasingly violent evaporation comes to impede the rewetting of the dry patches generated on the heater surface, which thus spread to cover the whole surface. A maximum value is observed in the slow burnout heat flux plotted against exit steam...