Heat and Mass Transfer Study of a High-Pressure Membrane Dehumidifier Under Non-Isothermal and Humid Sweep Psychrometric Conditions

Abstract

Abstract High-pressure membrane dehumidification is of interest for aircraft environmental control system applications. Typically, membrane dehumidifier modules are characterized by manufacturers over a range of mass flow rates, temperatures, and pressures at saturation conditions. However, to evaluate the suitability of high-pressure membrane dehumidification for aircraft applications, the performance must be characterized over the broader range of psychometric conditions that could be encountered. Moreover, the practical integration of a membrane dehumidifier into an environmental control system necessitates reconsideration of the traditional product sweep approach, where some of the dry air produced is removed and supplied to the other side of the membrane to enhance mass transfer. In an environmental control system, using product sweep would require excessive bleed air from the engine and cause unbalanced flow in the turbomachinery. To avoid this, alternate sources of sweep must be considered and their effects on dehumidification must be evaluated. This work conducts an experimental investigation of a membrane dehumidifier module using product sweep under a range of psychometric conditions, then compares product and humid sweep modes to understand the effects of sweep conditions on dehumidification performance. Concurrently, a numerical model of a membrane dehumidifier is implemented and validated - first against the module specification sheet, then against the empirical results that represent moderate altitude aircraft conditions. Ultimately, the feasibility of a hot and humid sweep source to maintain sufficient dehumidification performance under realistic altitude conditions is demonstrated.