Abstract
The design of a <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$\textit{W}$</tex-math> </inline-formula> -band traveling-wave tube (TWT) power amplifier based on a groove gap waveguide (GW) slow-wave circuit is presented in this article. The technology of GW is analyzed to aid the design of electromagnetic band gap-based slow-wave structures (SWSs) in the upper millimeter wave range of the spectrum while alleviating some of the typical fabrication challenges at these frequencies. The results of particle-in-cell (PIC) simulations numerically demonstrate a 10-GHz instantaneous 3-dB bandwidth in the range 89–99 GHz with a minimum power gain of 25 dB. A prototype of the complete SWS is manufactured via computer numerical control (CNC) machining and measured to verify the cold simulation results. Machining tolerances and surface roughness are also investigated. The design approach via groove GW is flexible and can be extended to alternative rectangular waveguide-based SWSs.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
