Grinding and polishing of the inner surface of monolithic simplified restorations made of zirconia polycrystals and lithium disilicate glass-ceramic: Effects on the load-bearing capacity under fatigue of the bonded restorations

Abstract

This study evaluated the effect of grinding and polishing the inner surface of monolithic discs made of zirconia polycrystals (ZR) and lithium disilicate glass-ceramic (LD) on the load-bearing capacity under fatigue of the restorations bonded onto a dentin analogue material (epoxy resin). ZR and LD ceramic discs (10 mm in diameter, 1 mm in thickness) were produced and randomly allocated into 10 groups considering the internal adjustment approach: Ctrl – No adjustment; F – Grinding with fine diamond bur (46 μm); F + Pol – Grinding with fine diamond bur followed by polishing with 2 tips (finisher and polisher); FF – Grinding with extrafine diamond bur (30 μm); FF + Pol – Grinding with extrafine diamond bur followed by polishing. In addition, discs (10 mm in diameter, 2.5 mm in thickness) of fiber reinforced epoxy resin were produced. Afterwards, the intaglio surface of the ZR discs were air-abraded with 45 μm alumina particles for 10 s, the LD and resin epoxy discs were etched with hydrofluoric acid (5%/20 s and 10%/60 s, respectively), and the treated discs were primed as recommended. Each ceramic disc was luted onto the epoxy resin disc with resin cement. Then, the samples were tested under a step-stress fatigue test (20 Hz, 10,000 cycles/step, step-size of 100 N starting at 200 N, and proceeding until failure detection). Fractographic, topographic and surface roughness analysis were also performed. The adjustments (grinding with or without polishing) (ZR: 733–880 N; LD: 1040–1106 N) triggered a detrimental effect on the fatigue behavior in both ceramics compared with the absence of treatment (control group; ZR: 973 N; LD: 1406 N). The polishing step had no effect on fatigue findings. Thus, grinding the inner surface of the tested ceramics should be avoided wherever possible to prevent introducing damage and its detrimental effects on the fatigue behavior.