Abstract
Granulators cut extruded elastomer wires in small pieces, which can be used as starting raw material for injection molding. This contribution investigates the most relevant parameters of process and tool geometry for the granulation technology, with the aim of improving process efficiency and granule quality. Fiber-reinforced PA and ABS plastics have been analyzed using a dedicated test bench and finite element simulations. High-speed camera and various sensors were used to investigate the cutting process. The considered geometrical and kinematic parameters have been varied within a broad range in order to determine optimum values.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.