Abstract
Competitive growth and grain selection were simulated and analyzed during the directional solidification with the conditions for single crystal superalloy DD6 castings using Commercial software, ProCAST. A three dimensional cellular automaton (CA) model coupled with finite-element (FE) heat flow calculation was applied. Measurements at the grain scale were made using the EBSD method at the cross sections in the starter block and grain selector at an interval of 4 mm from the chill surface. The grain characteristics and the rules of competition growth were obtained. The validity of the simulation results were compared with those of the experiment. It concluded that the model-predicted tendency shows satisfactory agreement with the experiment. Increasing the distance from the chill decreases the number of grains, increases the radius of grains and drives the crystallization orientation of grains to principal stress orientation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
