Genesis of the Permian Baimazhai magmatic Ni–Cu–(PGE) sulfide deposit, Yunnan, SW China

Abstract

The ~260 Ma-old Baimazhai Ni–Cu–(PGE) sulfide deposit in the Jinping region, Yunnan, SW China, is hosted in a small mafic–ultramafic intrusion, which intruded Ordovician sandstone and slate. The intrusion is concentric with lens shape, about 530 m long, 190 m wide and 24 to 64 m thick, trends 296°, and dips 22°NE. The massive sulfide ore body forms the core of the intrusion and is surrounded by variably mineralized orthopyroxenite, websterite and barren gabbro. The proportion of gabbro, websterite, orthopyroxenite and massive ore is approximately 30, 30, 20 and 20 vol.%, respectively. Magmatic pyrrhotite, pentlandite and chalcopyrite make up more than 90% of the massive ores. The massive ores contain high Ni (1.6 to 4.2 wt%) and Cu (0.4 to 6.5 wt%) and low ∑PGE contents (85 to 524 ppb). They have Pd/Ir ratios ranging from 6.7 to 530, Pd/Pt ratios from 0.7 to 2.6 and Cu/(Pd×1,000) ratios from 31 to 400, which are comparable with those of the silicate rocks [Pd/Ir = 4 to 183, Pd/Pt = 0.7 to 3.5, and Cu/(Pd×1,000) = 100 to 400]. Similar Pd/Pt and Cu/Pd ratios of the silicate rocks and massive ores throughout the intrusion indicate a single sulfide segregation event. Excess sulfide melt segregation resulted from intensive crustal contamination that formed Si-rich and Mg-rich basaltic magmas in a deep-seated staging chamber before magma emplacement. The immiscible sulfide melts and the silicate melts were eventually evacuated from the staging magma chamber by compressive forces. Flow differentiation under high velocity concentrated the sulfide melts toward the middle of the magma flow, and consequently, formed a massive sulfide ore body in the central part of the intrusion. Low concentrations of PGEs and general absence of platinum-group minerals in the massive ores may have resulted from a relatively large mass fraction of the sulfide melts (e.g. R-factor = ~70) in Baimazhai compared with other intrusions elsewhere, such as Noril’sk-Talnakh with a R-factor of >10,000.