Abstract

AbstractThe application of fused filament fabrication (FFF) in vacuum changes the heat transfer of the process. This work investigates the influence of the working ambient pressure conditions in FFF-based 3D printing of polyetheretherketone (PEEK) specimens, and its impact on the resulting part strength. Layer adhesion drastically improves with decreasing pressure, maximum layer adhesion is reached for ambient pressure below $$10^{-3}$$ 10 - 3 mbar. We show that simple and low-cost vacuum equipment is sufficient to achieve such pressure conditions, making this process interesting for the general processing of high-temperature polymers using FFF.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.