Further Insight into the Photostability of the Pyrene Fluorophore in Halogenated Solvents

Abstract

Pyrene fluorophores of pyrene-functionalized CdSe quantum dots (QD@Py), as well as alkylpyrene and pyrene itself (Py), undergo fast degradation in aerated chloroform under ultraviolet-A (UV-A, 316<λ<400 nm) illumination. Steady-state fluorescence studies of irradiated chloroform solutions of QD@Py show formation of new bands, red-shifted compared to that of the pyrene moiety. Similar behaviour is observed for pyrene and the alkylpyrene system. Column chromatography of the pyrene photolysate in chloroform allowed us to isolate photoproducts arising from pyrene degradation, and to obtain information on the structure of the photoproducts responsible for the emission bands. The most predominant photoproducts were those originating from the reaction of pyrene with dichloromethyl radicals. The phototransformation of QD@Py and the alkylpyrene involves mainly detachment of the alkyl chain from the aromatic ring, induced also by dichloromethyl radicals, and oxidation of the alkyl chain at the benzylic position was detected as well. By contrast, these pyrene systems show a high photostability in aerated dichloromethane. Transient absorption measurements showed formation of both pyrene triplet and pyrene radical cation for all pyrene systems in these halogenated solvents. The yield of pyrene radical cations for Py is higher than for QD@Py and the alkylpyrene. In addition, pyrene radical cations were longer-lived in dichloromethane than in chloroform. The reason for the pyrene photostability in dichloromethane is the different reactivity of chloromethyl and dichloromethyl radicals towards pyrene and oxygen. These studies show that the use of dichloromethane can be a suitable alternative to chloroform when the good solubility properties of these halogenated solvents are needed to dissolve pyrene when this chromophore is used as a fluorescent probe.