Friction Model for Tool/Work Material Contact Applied to Surface Integrity Prediction in Orthogonal Cutting Simulation

Abstract

Tribological behavior at both tool/chip and tool/work material interfaces should be highly considered while simulating the machining process. In fact, it is no longer accurate to suppose one independent constant friction coefficient at the tool/chip interface, since in reality it depends on the applied contact conditions, including the sliding velocity and pressure. The contact conditions at both above mentioned interfaces may affect the thermal and mechanical phenomena and consequently the surface integrity predictions.In this article, the influence of contact conditions (sliding velocity) on the tribological behavior of uncoated tungsten carbide tool against OFHC copper work material was investigated. Series of tribology tests combined with numerical simulations of the contact process were performed under different sliding speeds and contact pressures, in order to identify the friction coefficient and the heat partition between OFHC copper and tungsten carbide. The friction coefficient in function of the sliding velocity was then integrated into a FE model of the orthogonal cutting of OFHC copper and applied to surface integrity prediction.