Abstract
Engineering critical assessment of offshore pipelines is usually very conservative if standardized single edge notch bend (SENB) specimens are used for the fracture mechanics testing. It is commonly accepted that the fracture toughness is dependent on the geometry constraint at the crack tip. The standardized SENB specimens have a high geometry constraint, and give lower bound fracture toughness for all geometries. For circumferential flaws in pipes the single edge notch tension (SENT) specimens is taken more into use, to establish more correct fracture toughness for the pipe in question. In this paper the effect of crack depth, misalignment and different wall thicknesses in SENT specimens have been studied. In addition the effect of crack depth and internal pressure in pipes have been studied with FE simulations.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.