Abstract
In the course of the work, the process of forming reflective shells and finding the position of grid elements after deformation was investigated. Fixation of mesh nodes by electric arc spraying. After that, a composite material such as polystyrene is applied to form reflective shells. Minimization of potential energy is carried out numerically by an iterative method. The result of the work is the formation of the antenna array shell by the method of electric arc spraying and the application of the composite material. The following forming operations of sheet metal stamping are known: drawing, rotary drawing, relief forming, trimming, including rubber and liquid drawing, hydromechanical drawing, explosion drawing, electric discharge stamping, electromagnetic stamping, hydropneumatic drawing, which allow to obtain a shell from sheet material (solid or gas and water permeable) by pressing it against a die or punch with a transfer medium.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Scientific journal of the Ternopil national technical university
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
