Folding of passive layers and forms of minor structures near terminations of blind thrust faults—application to the central Appalachian blind thrust

Abstract

The existence of detachment surfaces or décollement zones beneath folded rocks of the Valley and Ridge and Plateau provinces of the Appalachians has been recognized as an important condition of folding. Large folds at the border between the two provinces resulted primarily from repetition of strata by thrusting of blocks over ramp faults that connect detachement surfaces at different horizons. Some investigators have suggested that folds in the Plateau province of Pennsylvania were produced by splay faults arising from detachment surfaces, but field observations and theoretical analyses by Sherwin and by Wiltschko & Chapple suggest that the folds are a result of buckling of multilayered rocks above a décollement. An exception may be the Burning Springs anticline in West Virginia, which appears to have formed at the termination of a detachment surface. Investigation of the translation of an homogenous, viscous material above a flat detachment surface that terminates laterally indicates that the termination produces a broad, low-amplitude anticline in passive layering as a result of thickening induced by a gradient of shear stresses in the vertical direction. This thickening above the termination of a detachment is a mechanism of folding. If the viscous fluid contained mechanical layering, the fold would become amplified by buckling. Computations of stresses in the material indicate that minor faults should be generated first near the termination of the flat detachment surface. The Burning Springs anticline probably was initiated by termination of a detachment surface and subsequently amplified by buckling.