Fluid inclusion volatile analysis by gas chromatography with photoionization micro-thermal conductivity detectors: Applications to magmatic MoS 2 and other H 2O-CO 2 and H 2O-CH 4 fluids

Abstract

Eighteen fluid inclusion volatile peaks have been detected and identified from 1–2 g samples (quartz) by gas chromatography using heated (~105°C) on-line crushing, helium carrier gas, a single porous polymer column (HayeSep R; 10′ × 1 8 ″: 100 120 #; Ni alloy tubing), two temperature programme conditions for separate sample aliquots, micro-thermal conductivity (TCD) and photoionization detectors (PID; 11.7 eV lamp), and off-line digital peak processing. In order of retention time these volatile peaks are: N 2, Ar, CO, CH 4, CO 2, C 2H 4, C 2H 6, C 2H 2, COS, C 3H 6, C 3H 8, C 3H 4 (propyne), H 2O (22.7 min at 80°C), SO 2, ± iso- C 4 H 10 ± C 4 H 8 (1-butene) ± CH 3 SH, C 4H 8 (iso-butylene), (?) C 4H 6 (1,3 butadiene) and ± n- C 4 H 10 ± C 4 H 8 (trans-2-butene) (80 and −70°C temperature programme conditions combined). H 2O is analysed directly. O 2 can be analysed cryogenically between N 2 and Ar, but has not been detected in natural samples to date in this study. H 2S, SO 2, NH 3, HCl, HCN, and H 2 ca nnot be analysed at present. Blanks determined by crushing heat-treated Brazilian quartz (800–900°C/4 h) are zero for 80°C temperature programme conditions, except for a large, unidentified peak at ~64 min, but contain H 2O, CO 2, and some low molecular weight hydrocarbons at −70°C temperature conditions due to cryogenic accumulation from the carrier gas and subsequent elution. TCD detection limits are ~30 ppm molar in inclusions; PID detection limits are ~ 1 ppm molar in inclusions and lower for unsaturated hydrocarbons (e.g., ~0.2 ppm for C 2H 4; ~ 1 ppb for C 2H 2; ~0.3 ppb for C 3H 6). Precisions (1σ) are ~ ±1–2% and ~ ± 13% for H 2O in terms of total moles detected; the latter value is equivalent to ±0.6 mol% at the 95 mol% H 2O level. Major fluid inclusion volatile species have been successfully analysed on a ~50 mg fluid inclusion section chip (~7 mm × ~10 mm × ~100 μm). Initial inclusion volatile analyses of fluids of interpreted magmatic origin from the Cretaceous Boss Mtn. monzogranite stock-related MoS 2 deposit, central British Columbia of ~97 mol% H 2O, ~3% CO 2, ~ 140–150 ppm N 2, and ~16–39 ppm CH 4 (~300–350°C) are reasonable in comparison with high temperature (~400–900°C) volcanic gas analyses from four, active calc-alkaline volcanoes; e.g., the H 2O contents of volcanic gases from the White Island (New Zealand), Mount St. Helens (Washington, USA), Merapi (Bali, Indonesia), and Momotombo (Nicaragua) volcanoes are 88–95%, >90% (often >95%), 88–95% and ~93%, respectively; CO 2 contents are ~3–10%, 1–10%, 3–8%, and ~3.5%. CO 2/N 2 ratios for the Boss Mtn. MoS 2 fluids of ~ 190–220 are in the range for known volcanic gas ratios (e.g., ~ 150– 240; White Island). The ∑S content of the Boss Mtn. MoS 2 fluid prior to S loss by sulphide precipitation may have been ~2 mol% since CO 2/∑S molar ratios of analysed high-temperature volcanic gases are ~ 1.5. This estimate is supported by ∑S contents for White Island, Merapi and Momotombo volcanic gases of ~2%, ~0.5–2.5%, and ~2%. COS has been determined in H 2O-CO 2 fluid inclusions of interpreted magmatic origin from the Boss Mtn. MoS 2 deposit and the Tanco zoned granitic pegmatite, S.E. Manitoba at ~50–100 ppm molar levels, which are consistent with levels in volcanic gases. It appears that low, but significant, concentrations of C 2-C 4 alkanes (~ 1–20 ppm), C 2-C 4 alkenes (~ 1–480 ppb) and alkynes (e.g., C 3H 4) have been detected in magmatically derived fluids (Boss Mtn. MoS 2 deposit; Tanco granitic pegmatite). Significantly higher, low molecular weight hydrocarbon concentrations have been determined in a CH 4-rich (~ 2%), externally derived fluid of possible metamorphic or deep crustal origin trapped as inclusions in metasomatic wall-rock tourmaline adjacent to the Tanco pegmatite (e.g., 300/470 ppm C 2H 6; 50 90 ppm C 3H 8; 3–60 ppm C 2H 4 C 3H 6 n-C 4H 10 ).