Flow Grade-Based Success Rates, Complication Rates, and Balloon Pulmonary Angioplasty Patency for Total Occlusions

Abstract

BackgroundThe number of successfully recanalized total occlusions affects hemodynamic improvement after balloon pulmonary angioplasty (BPA) in patients with chronic thromboembolic pulmonary hypertension (CTEPH). We aimed to clarify the current efficacy, patency, and success rate of BPA for total occlusions. MethodsBetween April 2016 and August 2021, 178 BPAs were performed in 100 patients with CTEPH and total occlusions. The primary success and subsequent patency rates immediately before the second BPA procedure (follow-up) were compared between the segmental and subsegmental groups, based on the flow grade, which was defined as follows: 0, no reperfusion; 1, minimal reperfusion; 2, partial reperfusion; and 3, complete reperfusion. ResultsTotal occlusions were mainly located in the right lung (70%) and lower lobes (48%). The primary success rate was 88%, with significant improvements in oxygenation, hemodynamic parameters, and 6-minute walk test. The primary flow grade did not differ between groups. However, the proportion of lesions with a flow grade of 2 or 3 at follow-up was significantly higher in the subsegmental group than in the segmental group (84% vs 45%, respectively; P < 0.01). In multivariate analysis, flow grade in the acute phase (odds ratio [OR], 46.9; 95% confidence interval [CI], 12.54-176.78; P < 0.01) and subsegmental lesions (OR, 13.8; 95% CI, 3.24-58.94; P < 0.01) were independently associated with better patency (flow grade of 2 or 3) at follow-up. ConclusionsTotal occlusions can be safely and effectively treated with BPA. BPA for total occlusions may be preferable for subsegmental over segmental lesions.