Abstract
In this study, a two-disc shrink fit assembly was modelled in two dimension using ABAQUS/Standard to determine the interfacial pressures with respect to the interferences. Steel—steel and steel—aluminium material pairs were considered. Inner disc of the assembly was considered as hollow and solid shafts, respectively. The results indicate that the finite-element results were in good agreement with the analytical results. In the hollow shaft assembly, both the hollow shaft and the outer disc had non-uniform stress distribution. In the solid shaft assembly, uniform stress distribution for the solid shaft and non-uniform stress distribution for the outer disc were determined. It was pointed out that same pressure can be obtained by different interference with different material pairs. If the assembly has complex shapes, the finite-element method gives more comprehensive and accurate results than the analytical method.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.