Abstract
For achieving the accurate FE modeling of friction, a new analytical formula of the friction coefficient at tool-chip-workpiece interface is first derived, which takes into account the actual cutting tool's blunt radius rather than conventionally simplified sharp edge. And the mean friction coefficient μm applied to the FE model in HSM of Ti6Al4V is obtained by using three-method combination of the new analytical formula and the FE simulation as well as the experimental verification of outside-diameter grooving with uncoated carbide tool. The results show that μm is between 0.4 and 0.5 in the grooving speed range from 49.4 m/min to 122.5 m/min. The validity of μm value is further verified by the agreement of the simulated chip shapes with the experimentally measured SEM morphologies.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
