Filament extrusion of bioresorbable PDLGA for additive manufacturing utilising diatom biosilica to inhibit process-induced thermal degradation

Abstract

Bone scaffolds are often fabricated by initially producing custom-made filaments by twin-screw extruder and subsequently fabricating into 3D scaffolds using fused deposition modelling. This study aims to directly compare the effect of two alternative silica-rich filler materials on the thermo-mechanical properties of such scaffolds after extrusion and printing. Poly (DL-lactide-co-glycolide) (PDLGA) was blended with either 45S5 Bioglass (5 wt %) or Biosilica (1 and 5 wt%) isolated from Cyclotella meneghiniana a freshwater diatom were tested. Diatom-PDLGA was found to have similar mechanical strength and ductility to pure-PDLGA, whereas Bioglass-PDLGA was found induce a more brittle behaviour. Bioglass-PDLGA was also found to have the lowest toughness in terms of energy absorption to failure. The TGA results suggested that significant thermal degradation in both the Bioglass filaments and scaffolds had occurred as a result of processing. However, diatom biosilica was found to inhibit thermal degradation of the PDLGA. Furthermore, evidence suggested the agglomeration of Bioglass particles occurred during processing the Bioglass-PDLGA filaments. Overall, diatom biosilica was found to be a promising candidate as a bone filler additive in 3D printed PDLGA scaffolds, whereas Bioglass caused some potentially detrimental effects on performance.