Abstract
In the present study, the two-dimensional jet flow of Fe3O4-H2O nanofluid was numerically investigated in a microchannel. The main objective of this article was to study the impact of permanent magnets on both ferromagnetic hydrodynamic and thermal behavior. A ferromagnetic hydrodynamic model, which includes the Brown effect and thermophoretic effect, was applied to simulate the problem through solving momentum, energy, and volume fraction equations. In this regard, different results, including the velocity vector, temperature distribution, and Nusselt number, were analyzed. Moreover, the influence of Kelvin force, inlet opening, permanent magnets position, and Reynolds number were studied on the jet flow and heat transfer. The obtained results demonstrate these factors significantly affect the jet flow and heat transfer of Fe3O4-H2O nanofluid in the microchannel. Moreover, it was found that the magnetic field originating from permanent magnets can effectively solve the problem of local high temperature on the wall at low inlet opening. The heat transfer gain was the most obvious when the position of the permanent magnet was close to the microchannel entrance. When inlet opening and permanent magnets position are 1/4 and 1, respectively, the heat transfer gain was largest, reaching 35.2%.
Highlights
With the rapid development of microelectronics technology, the increasing heat flux puts forward higher requirements to dissipate the generated heat in electronic equipment [1,2]
It was found that the ratio of thermal conductivity of nanofluid to that of the base fluid increases has a direct correlation with the volume fraction, temperature, and diameter of nanoparticles
O nanofluid jet flow and convective heat transfer were affected by different parameters, volume fraction (φ), inlet opening (R), Reynold affected by different parameters, including volume fraction (φ), inlet opening (R), Reynnumber (Re), permanent magnet position (Xi ), Kelvin force number (γ), and so on
Summary
With the rapid development of microelectronics technology, the increasing heat flux puts forward higher requirements to dissipate the generated heat in electronic equipment [1,2]. In this regard, different technologies such as installing the fins, adding phase change materials were put forward [3,4]. Buongiorno et al [8] considered the sliding velocity between nanoparticles and fluid and proposed a non-uniform model in this regard. They showed that the particle velocity was mainly affected by the thermophoresis effect and Brownian motion. It was found that the ratio of thermal conductivity of nanofluid to that of the base fluid increases has a direct correlation with the volume fraction, temperature, and diameter of nanoparticles
Sign-in/Register to view highlights & summary Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
