Fatigue assessment of steel rollers using an energy based criterion

Abstract

Abstract: Weldments geometry with failures occurring at the weld toe or at the weld root cannot, by its nature, be precisely defined. Parameters such as bead shape and toe or root radius vary from joint to joint even in well-controlled manufacturing operations. The worst case configuration can be achieved by modelling as a sharp, zero radius, notch both the toe and the weld root. The intensity of asymptotic stress distributions obeying Williams' solution are quantified by means of the Notch Stress Intensity Factors (NSIFs). For steel welded joints with failures originated from the weld roots, where the lack of penetration zone is treated as a crack-like notch, units for NSIFs are the same as conventional SIF used in LEFM. The different dimensionality of NSIFs for different notch opening angles does not allow a direct comparison of failures occurring at the weld toe or at the weld root. In order to overcome the problem related to the variability of the V-notch opening angle, a simple scalar quantity, i.e. the value of the strain energy density averaged in the structural volume surrounding the notch tip, has been introduced. This energy is given in closed form on the basis of the relevant NSIFs for modes I, II and III. The radius Rc of the averaging zone is carefully identified with reference to conventional arc welding processes being equal to 0.28 mm for welded joints made of steel. The local-energy based criterion is applied here to steel welded rollers produced by Rulmeca subjected to prevailing mode I (with failures at the weld root). The aim of the paper is firstly to describe the employed methodology for the fatigue assessment and secondly to show the first synthesis of fatigue data by means of local SED for a specific geometry.