Fabrication of metal-based superhydrophilic and underwater superoleophobic surfaces by laser ablation and magnetron sputtering

Abstract

Fabricating underwater superoleophobic surfaces is an advanced technique for controlling undesirable oil and wax adhesion on engineering structures and household appliances. This article presented a facile method based on the combination of laser ablation of stainless steel substrates followed by magnetron sputtering of a metallic tungsten target to fabricate superhydrophilic and underwater superoleophobic surfaces. The results showed that the laser-ablated stainless steel substrate without coatings exhibited hydrophilicity and underwater oleophobicity. However, its transition to superhydrophilicity and underwater superoleophobicity with a 0° water contact angle and higher than 156° underwater oil contact angles occurred after the deposition of a thin tungsten film followed by annealing at 300 °C. The prepared surface maintained its wetting behavior for more than 4 weeks, even in corrosive aqueous HCl and NaOH solutions. According to the data from SEM and XPS, this distinguished wetting behavior resulted from the presence of the regular microscale texture patterns, abundant hydroxyl content, and low carbon content on the tungsten layer after annealing at 300 °C. Thus, laser ablation combined with magnetron sputtering of tungsten demonstrated effective results in fabricating superhydrophilic and underwater superoleophobic surfaces that are independent of the initial wetting of the substrates.